Publicidad
V I D E O P O R T E R O E L E C T R Ó N I C O - V I D E O D O O R E N T R Y S Y S T E M S - V I D É O P O R T I E R É L E C T R O N I Q U E
INSTRUCCIONES DE CONFIGURACIÓN DEL TECLADO
KEYPAD CONFIGURATION INSTRUCTIONS
INSTRUCTION DE CONFIGURATION DU CLAVIER
DESCRIPCIÓN - DESCRIPTION - DESCRIPTION
MENÚ DE INSTALACIÓN
Nota:
MENÚ DE USUARIO
Notas:
To configure the keypad there are two types of configuration menu: installation menu and user menu.
INSTALLATION MENU
Is used to configure the general parameters of the system as well as the features of the user menu. This menu is accessed from the
keypad of the entrance panel itself by keying in the MASTER code. The keypad leaves the factory with a default MASTER code which
allows access to the menu. It is possible to change this code inside the configuration menu (Position 6 from the installation menu).
The menu consists of 6 positions, each of which corresponds to a specific parameter. The key
allows you to move through the
different positions without modifying their value. A value must be changed if it does not meet the requirements of the installation.
Note: To prevent outside persons from having access to the menu, we recommend that you replace the default MASTER code by another
MASTER code. You can choose any number between 00000 and 99999.
USER MENU
Has two user menus. User menu 1, for controlling a door, and user menu 2, for controlling a second door. They will be used to change
the USER codes (position 1 of the menu) and the length of time the electric lock is activated (position 2 of the menu) for each memory
position. This USER menu is accessed from the keypad of the panel itself by keying in a USER code. This code will be specific to each
memory position (99 per door) and will also be used as the DOOR-OPENING code. If a memory position has not been programmed,
the USER code will be the same as the MASTER code. Once the USER code has been changed, it will only be possible to access the
memory position in question by entering the new code.
Notes: The user menu will only be accessible if it is enabled in the installation menu (position 5 of the installation menu).
The panel leaves the factory with all of the memory positions unprogrammed.
MENU D'INSTALLATION
Remarque:
MENU D'USAGER
Remarque:
Publicidad
