Publicidad
V I D E O P O R T E R O E L E C T R Ó N I C O - V I D E O D O O R E N T R Y S Y S T E M S - V I D É O P O R T I E R É L E C T R O N I Q U E
ENTRADA EN EL MENÚ DE USUARIO
ENTERING USER MENU
ENTRER EN MENU D'USAGER
Nota:
Nota:
Press the key marked
Next, enter the memory position which you wish to program. You can choose any number between 01 and 99 inclusive.
Press the key marked
Note: Remember that user menus 1 and 2 will store the codes and the configuration of the relays of electric locks 1 and 2 respectively.
If this is the first time that you are opening the user menu from this memory position, the red led will blink. Enter the MASTER code.
Otherwise, enter the USER code which you have previously configured for that memory position and which is the same as the access
code of the door.
If the code you have entered is correct, the entrance panel will emit a beep and the green led will flash once, indicating that you
are in position 1 of the menu (See page 20).
If the code is incorrect, the panel will emit a deep thudding sound and the red led will flash. Begin again at step 1.
Note: The maximum time allowed between steps is 15 seconds. Once this period has elapsed, you must begin again.See diagram below.
Remarque:
Remarque:
1
2
3
4
5
6
7
8
9
C
0
9
1
2
3
4
5
6
8
9
7
C
0
once if you wish to open user menu 1 and twice if you wish to open user menu 2.
again. The red led on the panel will light up, remaining lit until you enter a USER code.
9
Red led lit up
3
Incorrect code
3
1
2
3
4
5
6
8
9
7
C
0
Insert code
1
2
3
4
5
6
8
9
7
C
0
Red led lit up
1 Flash green led
1
1
2
3
4
5
6
7
8
9
C
0
Position 1 of the menu (page 20)
Publicidad
