Publicidad
C
x2
Surface mount installation
Drywall
D
x2
B
x4
1/4 in.
E
x4
DRYWALL INSTALLATION: Mark a distance of 32 in. apart, where the mounting
brackets (D) will be located. While holding the mounting bracket in place, trace
the both holes in the mounting bracket. Using a 1/16 in. drill bit, drill 2 pilot holes at
each mark for both mounting brackets (D). If no stud is encountered, use a 1/4 in.
drill bit and drill a hole for the ceiling anchors (B). Pinch the ceiling anchor (B)
sides together and insert it into the hole. Push or tap the ceiling anchor (B) into
place until the underside is against the ceiling. Align the mounting brackets (D)
with the anchors and drive screws into place.
Lift the fixture toward the mounting brackets (D) while aligning the
top of the fixture channel with both clips. Apply upward pressure
until channel snaps into place and seats into both brackets.
Plug fixture into electrical outlet.
Optional: Installing additional lights
Plug cord into linking outlet. Can link up to 5 fixtures total.
NOTE: Install additional fixture within 5ft cord length.
Insert the bottom loop of the mounting chains (A) into the "S" hooks (C). Straighten
out and remove kinks in the chain. Insert the opposite end of the "S" hook through
the keyhole slot located on the top of the fixture located at near both ends. Crimp
the "S" hook (C) to the chain and then to the mounting hole in the fixture for a more
secure installation. NOTE: chains will support the weight of the fixture.
The installation is complete. Plug fixture into an electrical outlet.
D
x2
E
x4
WOOD INSTALLATION: Mark a distance of 32 in. apart, where the
mounting bracket (D) will be located. While holding the mounting bracket
in place, trace the both holes in the mounting bracket. Using a 1/16 in. drill
bit, drill 2 pilot holes at each mark for both mounting brackets. Align the
mounting brackets with the anchors and drive screws into place.
Controls
Wood
1/16 in.
PIR SETTINGS
MANUAL: Light stays on continuously.
Can be turned off with a wall switch.
AUTO: The light turns on when the
motion sensor detects movement. 120
degree sensor detects motion up to 8 ft.
Light automatically turns off after 5
minutes with no motion detected.
Care and Maintenance
Periodically clean the fixture and diffuser using a mild,
non-abrasive cleaner and soft cloth. When cleaning
the fixture, make sure the power is turned off. Do not
spray cleaner directly onto any part of the fixture on
LEDs.
2
Publicidad
