Troubleshooting; Warranty - Harbor Breeze POINT BREAK Manual Del Usuario

TROUBLESHOOTING (continued from previous page)
Problem (cont.)
Excessive wobbling.
Fan operates but light fails
(if applicable).
Note: A small amount of "wobble" is normal and should not be considered a defect.

WARRANTY

LIMITED LIFETIME WARRANTY: Litex Industries warrants this fan to be free from defects in workmanship and
materials present at time of shipment from the factory for Lifetime limited from the date of purchase. This warranty
applies only to the original purchaser. Litex Industries agrees to correct any defect at no charge or, at our option,
replace the ceiling fan with a comparable or superior model.
To obtain warranty service, present a copy of your sales receipt as proof of purchase. All cost of removal and
reinstallation are the express responsibility of the purchaser. Any damage to the ceiling fan by accident, misuse or
improper installation, or by affixing accessories not produced by the manufacturer of this fan, are the purchaser's
own responsibility. Litex Industries assumes no responsibility whatsoever for fan installation during the limited
lifetime warranty. Any service performed by an unauthorized person will render the warranty invalid.
Due to varying climatic conditions, this warranty does not cover changes in brass finish, rusting, pitting, tarnishing,
corroding or peeling. Brass finish fans maintain their beauty when protected from varying weather conditions. Any
glass provided with this fan is not covered by the warranty.
Any replacement of defective parts for the ceiling fan must be reported within the first year from the date of
purchase. For the balance of the warranty, call our customer service department
authorization and shipping instructions so that we may repair or replace the ceiling fan. Any fan or parts returned
improperly packaged is/are the sole responsibility of the purchaser. There is no further express warranty. Litex
Industries disclaims any and all implied warranties. The duration of any implied warranty which cannot be
disclaimed is limited to the limited lifetime period as specified in our warranty. Litex Industries shall not be liable for
incidental, consequential or special damages arising at or in connection with product use or performance except as
may otherwise be accorded by law. This warranty gives you specific legal rights and you may also have other rights
which vary from state to state. This warranty supersedes all prior warranties.
Possible Cause (cont.)
1. Blades (H) are loose.
2. Blade arms (G) incorrectly attached.
3. Unbalanced blades (H).
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
6. Set screw(s) on motor housing yoke
is (are) not tightened properly.
7. Set screw on hanging ball is not
tightened properly.
1. Bulb(s) not installed correctly.
2. Wires in canopy (B) not wired properly.
3. Wall switch to fan is off.
4. Wires in switch housing (D) not wired
properly.
Corrective Action (cont.)
1. Tighten all blade screws (M).
2. Re-install blade arms (G).
3. Switch one blade (H) with a blade (H)
from the opposite side or use blade
balancing kit (Q) included.
4. Turn power off. Carefully loosen
canopy (B) and verify that mounting
bracket (C) is secure.
5. Use a longer downrod (A) or move fan
to another location.
6. Tighten yoke set screw(s) securely.
7. Carefully loosen and lower canopy (B)
and verify that set screw on hanging ball
is tightened securely.
1. Re-install bulb(s).
2. Check wires in canopy (B) and, if
necessary, re-wire according to
instructions on pages 6 and 7.
3. Make sure that wall switch to fan is on.
4. Check wires in switch housing (D) and,
if necessary, re-wire according to
instructions on page 8.
10
(at 1-800-527-1292) for return
Printed in China