Nilfisk VL100 35L Instrucciones De Uso página 8

remove the motor head assembly. Shake and clean the filter assembly into the
container.This should be done while the hose is still connected to avoid dust exiting
from the open hose connection. Having shaken the filter, allow a few moments for the
dust to settle. Remove the dust filter assembly from machine and empty the container.
If the filter's surface appears to be heavily contaminated, it is advisable to brush the
filter material clean with an ordinary soft household brush. This ensures continued
peak performance. Having emptied the container, replace the dust filter assembly,
replace the motor head assembly and lock tank catches. You are now ready to start
again. If the above procedure does not resolve the low suction, please check if the
suction hose is blocked.
(Dry Control and Operation is referred to in Page 3 "F3")
Use crevice tool for narrow spaces eg narrow gaps and corners (Control and
Operation is referred to in Page 3 "F7")
Use Dusting tool to clean more sensitive or fabric surfces e.g. curtains (Control and
Operation is referred to in Page 3 "F6")
Wet Operation
Ensure to empty any dry dust from the container before using the machine for wet
pick-up.
Always be sure to use wet pick-up tool with rubber blades.
Take out dust bag for wet applications, If the fluid is likely to generate foam, we
suggest use the Dry Filter Assembly, which will help prevent foam entering the motor
head. When the container fills to its maximum, the suction will stop and the sound of
the machine will increase. Switch off the machine and remove the power cord.
Remove the motor head and float valve assembly.
Move the machine to the drain and empty the liquid from the container via the drain
hose.
If the suction power becomes lower, the float and filter system may require cleaning.
Switch off the machine, remove the power cord and loosen the float basket by turning
the basket to the left. A filter is located in the float basket. Check and clean the filter,
then reinstall the float system, and make sure that the cup's "TOP' side is installed
upwards in the direction towards the motor top. To mount the float basket-align the
arrow on the basket to the arrow on the housing. Then secure the float basket by
turning it to the right. (Control and Operation can be referred Page 3 "F4")
Warranty
For your warranty terms, please contact your local Nilfisk Service Centre
Attention!!! Before performing any cleaning and maintenance on the vacuum cleaner,
always disconnect the plug from the power source.
1. Make sure that the cable is not broken or damaged.
2. Clean the container, do not let it stand for a long time with dust or dirty water.
3. The cloth dust bag can be washed and must be dried again before re-use
4. The motor is built for maintenance-free operation and does not need any particular
8