Kohler 22036-CP Instrucciones De Instalación página 12

Handle LED Adjustment
IMPORTANT! Do not apply upward pressure to the valve setscrew while making
adjustments.
NOTE: The LED should turn ON as the handle is rotated open, and OFF when the
handle is in the upright (closed) position. Use a 5/64" hex wrench to adjust the valve
setscrew as needed.
LED is ON when the handle is closed: Tighten the valve setscrew until the LED
turns OFF. Then tighten the setscrew an additional 1/4 turn.
Handle does not return to the upright position: Loosen the valve setscrew until
the handle rotates to the full upright (closed) position and the LED turns ON.
Then tighten the setscrew until the LED turns OFF, plus an additional 1/4 turn.
Water does not fully shut off: Loosen the valve setscrew until the handle rotates
to the full upright (closed) position and the LED turns ON. Tighten the setscrew
until the LED turns OFF, plus an additional 1/4 turn.
1384293-2-C
Sensor
Open Position
12
Handle
Closed
LED
Position
Setscrew
Kohler Co.