Kohler 22036-CP Instrucciones De Instalación página 15

Symptoms
2. Low water
flow.
3. Poor spray
pattern.
4. Power LED is
not lit.
5. Water drips or
trickles when
faucet is not in
use.
Kohler Co.
Probable Cause
A. The supply stops
are partially closed.
B. Handle is partially
closed.
C. The hot and/or
cold supply hose is
kinked or twisted.
D. The outlet hose is
kinked.
E. One or more
screens are
clogged.
F. Cracked
diaphragm.
A. The spray nozzles
are clogged.
A. No power to the
circuit board.
B. Power cord is
plugged into a
switched outlet.
A. Manual override is
partially engaged.
Recommended Action
A. Confirm that the supply stops are
fully open.
B. Rotate the handle to the full open
position.
C. Confirm that the supply hoses are
not kinked or twisted. If coiled,
maintain an ID of 3" (76 mm).
D. Confirm that the solenoid valve is
within 7" (178 mm) to 8" (203
mm) from the faucet centerline.
E. Refer to the "Cleaning the
Screens" section.
F. Replace the solenoid valve
assembly.
A. Rub your finger over the nozzles
with water running to dislodge
debris.
A. Check the power supply
connections to the circuit board.
B. Plug the power cord into an
unswitched 120 VAC outlet (test
the outlet with a radio or other
device). Confirm that the power
LED illuminates.
A. Turn the manual override
clockwise until it stops; then turn
it counterclockwise until the
water drip stops.
15
1384293-2-C