Troubleshooting - PULOX PO-200A SOLO Manual De Instrucciones

time.
 The best storage environment of the device is -40ºC to 60ºC
ambient temperature and not higher than 95% relative humidity.
High-pressure sterilization cannot be used on the device.
Do not immerse the device in liquid.
It is recommended that the device should be kept in a dry
environment. Humidity may reduce the useful life of the device,
or even damage it.

8. Troubleshooting

Trouble
The SpO2 and
Pulse Rate can
not be
displayed
normally
The SpO2 and
Pulse Rate are
not displayed
stably
The device can
not be turned
on
The display
suddenly turns
off
9. Key of Symbols
Symbol Description
Type BF applied part
Refer to instruction
Possible Reason
1. The finger is not properly
positioned
2. The patient's SpO2 is too
low to be detected.
1. The finger is not placed
inside deep enough.
2. The finger is shaking or
the patient is moving.
1. The batteries are drained
or almost drained.
2. The batteries are not
inserted properly.
3. Malfunction of the
device.
1. The device will power off
automatically without signal
within 5 seconds.
2. The battery is almost
drained.
Solution
1. Place the finger
properly and try
again.
2. Try again; Go to a
hospital for a
diagnosis if you are
sure the device works
properly.
1. Place the finger
properly and try
again.
2. Calm thw patient
down
1. Change batteries
2. Reinstall batteries.
3. Please contact the
local service center.
1. Turn on the device
and insert finger.
2. Change batteries
Symbol Description
Menu/ Power button
Sound prompt on
EN