Kohler Sterling 14700 Guia De Instalacion página 4

Sealant
Cut-Out
Apply a bead of sealant to the lip of
the sink and set it in the mounting
hole.
2. Install the Faucet Fitting
- Install faucet and drain fitting according to manufacturer's
instructions. If you are reusing fittings from an old sink, use
plumbers putty under the faucet base and top flange of the drain.
3. Attach the Sink
- Apply a bead of silicone or latex sealant around the edge of the sink.
- Set the sink into the cut out and position squarely.
- Push the metal leg of the clip tight against the bottom of the
countertop.
- Tighten the hex nuts evenly, tightening the middle clips first and
then the corners, from under the sink until the rim is sealed.
CAUTION: Risk of property damage. Do not overtighten. It is
only necessary to draw the rim down firmly to the countertop.
- Wipe excess sealant from countertop with a dry cloth.
- Double check for gaps.
NOTE: Fasteners may need to be repositioned to compensate for an
uneven countertop.
4. Finish the Installation
- Connect the drain and faucet supply fittings.
- Turn on the main water supply and check for leaks.
C
1014305-2-
Slide the metal leg tight to the
countertop prior to tightening the nuts.
Sink Edge
Countertop
Mounting
Clip
Metal Leg
Back View Of
Mounting Clip
4
Nut
Sterling