Configuration (Standalone) - Chauvet SCORPION GBC EU Manual Del Usuario

Configuration
(DMX)
Starting Address
(all models)
Configuration
(Standalone)
Sound Mode (GBC
EU, RBM EU, and
RGY EU)
Page 16 of 68
Setting this product to operate in DMX mode will allow you to control it with a DMX
controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket of this product.
When selecting a starting DMX address, you must always consider the number of DMX
channels assigned to the selected DMX mode. If you choose a starting address that is
too high, you could restrict the access to some of the channels of the DMX mode in use.
The Scorpion™ GBC EU/RBM EU/RGY EU/BLU EU fixtures use ten DMX channels,
which defines the highest configurable address to 503.
If you are not familiar with the DMX protocol, you may refer to the "DMX Primer" section
in the "Technical Information" chapter.
To select the starting address, do the following:
1. Press <MENU> repeatedly until the current starting address (001 to 503) shows
blinking on the display.
2. Use <UP> or <DOWN> to select a different starting address (001~503).
3. Press <ENT> (the new starting address will show solid on the display).
Setting this product to operate in DMX mode will allow you to control it without a DMX
controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
Never connect a fixture that is operating in any standalone mode, whether Static,
Automatic, or Sound to a DMX string connected to a DMX controller. This is
because fixtures in standalone mode may transmit DMX signals that could
interfere with the DMX signals from the controller.
To enable the Sound mode, do the following:
1. Press <MENU> repeatedly until the active option of the Auto/Sound branch (AF1 to
rdM) appears on the display.
2. Use <UP> or <DOWN> to select a sound triggered program (So1~SoM).
3. Press <ENT> (the new sound program will show solid on the display).
4. Turn the music on.
5. Press <MENU> repeatedly until the active option of the Sound Sensitivity branch (S
0 to S 9) shows blinking on the display.
6. Use <UP> or <DOWN> to select the sensitivity level (S 0~S 9).
7. Press <ENT> (the new sound sensitivity will show solid on the display).
The fixture will only respond to the low frequencies of the music (bass and
drums).
NOTE: There are individual differences in responses to music between
Scorpions™ set to the same Sound-active mode (S0~S9). To ensure an in-unison
effect from multiple lasers, link them together in Master/Slave mode. The slave
products will operate according to the master unit's Sound-active setting.
Scorpion™ GBC EU/RBM EU/RGY EU/BLU EU User Manual (Rev. 5 ML)