3
Insert lag bolt anchors [13].
CAUTION:
property damage be sure the anchors [13] seat
fl ush with the concrete surface.
To avoid potential injuries or
[13]
Start upper lag bolts [14], hang frame assembly
4
on bolts [14], then slip "U" washers [11] onto
the upper bolts [14]. Lower bolts [14] use round
washers [12].
13mm
Tighten lag bolts [14] only until the washers [12]
(1/2 in.
)
and [12] are pulled fi rmly against the brace [03].
CAUTION:
holding power of the lag bolt. To avoid potential
injuries or property damage DO NOT over-
tighten the lag bolts [14].
Improper use could reduce the
[11]
[14]
[03]
[12]
[14]
[03]
15