Kohler K-8524 Guia De Instalacion página 4

Post
2. Install the Slide Bar
While holding the post, thread the pin into the post. Tighten with
a flat blade screwdriver. Repeat for the other pin.
Line up the hole in the lock assembly with the hole in the slide
bar. If needed, use a small screwdriver to adjust the position of
the lock assembly. Repeat for the other lock assembly.
Align the pins with the holes in the slide bar and lock assembly.
Gently press the slide bar against the posts, inserting the pins into
the lock assemblies. The slide bar should fit snug against the
posts.
Secure the slide bar by tightening the setscrews into the lock
assemblies until the setscrew is snug against the pins.
Press the caps into either end of the slide bar.
1046145-2-A
Pin
Lock Assembly
Setscrew
O-Ring
Cap
4
Handshower
Holder
Slide Bar
Kohler Co.