Replacing Anvil - Uline H-3068 Manual Del Usuario

REPLACING ANVIL

Release the pin/screw (512/514) and take away anvil (029).
Assemble the new anvil (029) and pin/screw (512/514).
Insert single staple into driver guide (016), leaving points pro-
truding.
Pull driver guide (016) down, until staple points contact
anvil (029).
Align anvil (029) with staple points by turning screw (506).
When anvil (029) is properly aligned, tighten pivot screw (521)
first, then tighten retaining screw (514).
PAGE 9 OF 39 0321 IH-3068