Regulations; Assistance; Risk Prevention - SOMFY ROLLIXO RTS Manual De Instalación

Rollixo RTS
For operation in automatic mode, or if the garage door faces
a public road, an orange light type signalling device may be
required to comply with the regulations in the country in
which the drive is installed.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection ( special glasses, gloves, ear
protection, etc.).

1.7 Regulations

Somfy declares that the product described in these
instructions, when used in accordance with the instructions,
complies with the essential requirements of the applicable
European Directives, and in particular Machinery Directive
2006/42/EC and Radio Equipment Directive 2014/53/EU.
The full text of the EC declaration of conformity is available
on the following website: www.somfy.com/ce. Antoine
CREZE, Head of Regulations, Cluses.

1.8 Assistance

installing your drive.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions.
Internet: www.somfy.com
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.

1.9 Risk prevention

Risk prevention - roller garage door drive for
residential use
> Risk zones: measures to be taken to eliminate risks.
Zone 3
Zone 4
RISK
ZONE 1
Risk of crushing
between the ground
and the lower edge of
the door during closing
ZONE 2*
Risk of crushing
between the casing
and door
ZONE 3*
Risk of cutting or
trapping between the
door slats in gaps of
between 8 mm and 25
mm
ZONE 4*
Risk of crushing
between the runners
and door
* For zones 2, 3 and 4, no protection is required if the door
has continuous control or if the danger zone is more than
2.5 m above ground or any other permanent access level.
WARNING
Zone 2
Zone 1
SOLUTION
Obstacle detection by the
safety edge solution Obstacle
as compliant with Appendix A
of standard EN 12 453
For operation with automatic
closing, install photoelectric
cells (see installation manual)
and door
Eliminate all sticking points
and all sharp edges from the
surface of the door
Eliminate any sharp edges
from the runners
between the runners and the
door
3