Memorising An Xse Safety Edge Transmitter; Clearing The Remote Controls; Clearing A Remote Control; Clearing All Remote Controls - SOMFY ROLLIXO RTS Manual De Instalación

Rollixo RTS
10 - MEMORISING AN XSE SAFETY EDGE
TRANSMITTER
Memorising a new radio safety edge transmitter overwrites the previous
transmitter.
[1]. Press button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog
the transmitter and receiver communicate with each other).
The transmitter is memorised in the receiver.
[1]
1 2 3 4
Prog
STOP
[2]
4 s
1 2 3 4
Prog
STOP

11 - CLEARING THE REMOTE CONTROLS

11.1 Clearing a remote control

Executing "Remote control memorisation" procedures on an already memorised
remote control clears it.

11.2 Clearing all remote controls

[1]. Press button on the receiver (for approximately 7 seconds) until the
Prog
indicator light above it goes out.
[2]. Release button on the receiver when the indicator light goes out; the
Prog
All memorised remote controls will be cleared.
Prog Prog
Press and hold down for 7 seconds
12
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
Prog Prog Prog
12 - DELETING A SAFETY EDGE
TRANSMITTER
Note: This operation must be carried out when a radio safety edge is replaced
with a wired safety edge.
[1]. Press button on the receiver (for approximately 14 s) until the indicator
Prog
light above it goes out.
[2]. Release button
Prog
The safety edge transmitter is cleared.
Prog
Prog Prog
Press and hold down for 14 seconds
13 - LOCKING/UNLOCKING THE
PROGRAMMING BUTTONS
The programming buttons must be locked to ensure user safety. Failure to
follow this instruction may result in serious injury, e.g. due to crushing by the
gate.
When the programming buttons are locked, the following functions cannot be
accessed:
- entering programming mode by pressing button
- entering motor end limit setting mode by pressing buttons

receiver

- setting the operating modes.
To lock the programming buttons, press buttons
STOP
STOP
To lock the programming buttons, repeat the locking procedure described
above.
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
Prog Prog Prog
WARNING
on the receiver
Prog
and
and on the receiver
Prog
STOP
1 2 3 4
Prog
1 2 3 4
Prog
on the