GBD SC230 Instrucciones Para La Instalación página 16

16
UK
DESRCIZIONE MENU ( A ) 12 - MANUAL MANOEUVRE
If the gate is unlocked and moved manually, with the electronic card powered, the control unit is reset and the following movement
will be an opening.
Position the gate into the stroke defined by the limit switches before locking the operator again.
13 - FINAL CHECKS DESRCIZIONE MENU ( A )
Check the electrical connections: an improper connection may be harmful to both the control unit and the operator.
Ÿ
Check the correct position of the limit switches.
Ÿ
Always preset the mechanical stops in opening and closing.
Ÿ
Check the correct operation of photocells and safety devices.
Ÿ
Check that the motors are blocked and ready to work with GATE HALFWAY POSITION.
Ÿ
Remove possible obstacles in the operating area of the gate.
Ÿ
Check that the direction of gate motion is correct:
Ÿ
take off the power supply from the control unit.
§
power the control unit.
§
give a START command.
§
check that the gate is opening, otherwise take off the power supply from the control unit and invert the wires of terminal
§
M2
Check the correct operation of the automation.
Ÿ
DESRCIZIONE MENU ( A ) 14 - FLASHING LIGHT SIGNALLING SUMMARY
Photo intercepted at rest in presence of START
command ( DIP5 = ON )
Test photo failed
Frame intercepted before the motion
Test frame 8K2 Failed (terminal 11)
Test frame 8K2 Failed (terminal 12)
Device Signalling
5 fast flashings
4 slow flashings
3 slow flashings
2 slow flashings
1 slow flashing
SC230
Effect
When released, it opens
Door blocked
Door blocked
Door blocked
Door blocked