Publicidad
Idiomas disponibles
Idiomas disponibles
®
Additional Operating Information
SETTING THE HEIGHT LIMIT:
To set the travel height limit of your lift system -
1. Using the up/down button, extend the lift column until the bottom of the monitor screen is flush with the table top surface.
2. Install the height limit insert into the control box port (noted below). This will store the current height setting.
CONTROL BOX
CONTROL BOX CABLE
HEIGHT
LIMIT
INSERT
ADJUSTING THE HEIGHT LIMIT:
If it is necessary to adjust or set the travel height limit of your lift system -
1. Remove the height limit insert from the port on the control box
2. Using the up/down button, extend the lift column to desired height.
3. Reinstall the height limit insert back into the control box port. This will store the adjusted height setting.
REINITIALIZE:
It may become necessary, to reset the resting height of the lifting column. To reinitialize the lift column
refer to the Initializing information on page 11.
RESETTING LIFT FROM SAFE MODE:
"Safe Mode" occurs when there is an interuption in the power supply when the lift is in operation. This function is noted
by the lift column operating at half speed or less. To reset from safe mode -
1. With power restored, press and hold the down button until the lift is fully retracted.
2. Follow the Initializing procedure from page 11.
UP/DOWN SWITCH CABLE
5 of 66
P/N 1094808001
Doc # 94775 Rev D
Publicidad
