Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. MAINTENANCE OPERATIONS. RECOMMENDATIONS.
In order for the equipment to have a long life we
must follow some essential rules for maintenance
and use. Abide by these recommendations.
CORRECT MAINTENANCE OF THE EQUIPMENT
WILL AVOID A GREAT PERCENTAGE OF FAULTS.
6.1 MACHINE MAINTENANCE. GENERAL
RECOMMENDATIONS.
Before carrying out any operation on the machine
or welding cables, we must place the switch of the
equipment in position of machine disconnected.
Specialized personnel must handle the machine to
carry out maintenance and repair operations.
A-
BLOW THE INSIDE OF THE MACHINE WITH
COMPRESSED AIR FROM TIME TO TIME.
The accumulation of metal dust on the inside is one
of the main causes of breakdowns in this type of
equipment as they are subject to a great amount of
pollution. As an essential measure, the equipment
must be kept separate from the welding place, not
placing it a short distance away. Keeping the
machine clean and dry is essential. The inside must
be blown as required. We must avoid any anomaly
or deterioration due to the accumulation of dust.
Blow the inside of the equipment with clean dry
compressed air. As routine to guarantee that the
equipment works correctly, check that once the
machine has been blown the electrical connections
are still properly tightened.
WARNING!:
SEPARATE
SUFFICIENTLY FROM THE WORKSTATION.
PREVENT METAL DUST ENTERING THE EQUIPMENT.
B-
LOCATE THE EQUIPMENT IN A PLACE
WHERE CLEAN AIR IS CONSTANTLY
REPLACED.
The machine ventilations must be kept free. It must
be located in a place where clean air is renewed.
C- THE MACHINE MUST ALWAYS BE
OPERATED WITH THE HOUSING ON.
machine immediately, wait until the inner cooling
system has totally cooled it.
6.2 RECOMMENDATIONS FOR REDUCING
ELECTROMAGNETIC COMPATIBILITY (CEM) PROBLEMS.
of the welding material according to the instructions
in this manual and the following recommendations.
of the following in the surrounding area must be kept
in mind:
• Wiring
• Radio and television receivers and transmitters.
• Computers and other control equipment.
• Critical security equipment.
• People with pace makers or hearing aids.
• Measurement and calibration equipment.
THE
MACHINE
the time of day when welding or other activities will
be carried out. Move possible interference victims
away from the welding installation.
D- DO NOT DISCONNECT THE MACHINE IF IT
IS HOT.
If you have finished the work do not disconnect the
E- KEEP THE WELDING ACCESSORIES IN
GOOD CONDITIONS FOR USE.
F- ONCE THE WELDING OPERATION HAS
FINISHED AVOID DIRECT CONTACT OF
THE ELECTRODE-HOLDER CLAMP WITH
THE WELDING EARTH CLAMP AND THE
OTHER PARTS CONNECTED TO IT.
The user is responsible for the installation and use
Before installing the welding material, the presence
for
power,
telephones.
In order to reduce EMC problems, keep in mind
ALWAYS CONNECT THE CHARGER TO POWER
USING AN EFFICIENT EARTH TAP.
PERFORM THE MAINTENANCE OPERATIONS
DESCRIBED IN THIS MANUAL.
USE THE SHORTEST WELDING WIRES POSSIBLE
AND KEEP THEM PLACED NEXT TO EACH OTHER
NEAR THE FLOOR.
control,
signalling,
and
Publicidad
Tabla de contenido
