Forch 5482 125 Manual De Instrucciones página 17

Butane Gas - Soldering Iron 125 W
ENG
Note
Please read this instruction manual carefully before first operation of this
■
equipment.
It contains numerous notes with regard to the intended use of the device. Keep
■
this instruction for future reference.
The Soldering Iron must be filled with butane gas before first operation.
■
Safety Notes
Keep away from children.
■
Make sure to keep soldering tip always away from face and body
■
Use safety goggles
■
Unit contains flammable gas (butane) under pressure. Use the device carefully.
■
Do not expose to sun or temperatures higher than +50 °C for a longer period of
■
time
Take into consideration that torch flame is nearly invisible in daylight or other
■
light sources
Do not refill near open flames, heater or furnace
■
Only refill and use in well-ventilated area
■
Never leave the unit unattended when it is in operation or still hot
■
Always make sure the unit is cool before storing
■
Do not touch the tip of the soldering iron at the unit when in operation or still
■
hot
Do not replace cap without having switched off the device and made sure that
■
the tip has cooled.
Do not try to open or repair the soldering iron (loss of warranty resp. guarantee)
■
Refilling
Only use commercially available butane gas (FÖRCH Art.-Nr.: 5482 20 125)
■
Make sure the ON/OFF-switch is in OFF-position before refilling
■
Shake the refill can to allow the gas to warm slightly. Gas transfer is dependent
■
upon gravity
Soldering iron is filled as soon as you have a gas overflow. Wait min. 1 min. for
■
the gas to stabilize
Ignition and Operation
Screw on the catalyst cap with the selected tip or the hot air nozzle
■
Make sure that the air exhaust hole of the soldering tips for hot air is positioned
■
upwards
Set gas control level at mid position
■
Push the ON/OFF-switch upward in direction of the soldering tip to the max.
■
point to release the gas flow and ignite the soldering iron
Release the switch after ignition to stay in the ON-position and the soldering
■
iron to be on
After successful ignition the inside of the attachments will glow in orange
■
colour after 1 to 2 seconds