Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Set the camshaft pulley to TDC. Align the TDC marks on the camshaft pulley to the cylinder head surface.
3.
Install the timing belt tightly in the sequence shown. (1) Timing belt drive pulley (crankshaft) -> (2) Adjusting pulley -> (3)
Water pump pulley -> (4) Camshaft pulley.
NOTE: Make sure the timing belt drive pulley and camshaft pulley are at TDC.
4.
Loosen and retighten the adjusting bolt to tension the timing belt.
5.
Install the lower cover and upper cover.
NOTE: Clean the upper and lower covers before installation.
6.
Install the crankshaft pulley, then tighten the pulley bolt.
7.
Rotate the crankshaft pulley about five or six turns counterclockwise so that the timing belt positions on the pulleys.
8.
Adjust the timing belt tension.
Publicidad
