Parts And Controls; Before Using For The First Time; Boiling Water - Bosch TWK720 Serie Instrucciones De Uso

Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you a
lot of enjoyment.

Parts and controls

1 Kettle (with water level indicator)
2 Lid
3 Lid release button
a
4 On/Off button
5 Temperature setting (illuminated display)
6 U button (keep warm)
7 Limescale filter (removable)
8 Base
9 Cable tidy
Important: The kettle should only be used
with the base supplied.
■ The kettle should only ever be filled
with water. Milk or instant products will
burn and damage the appliance. Never
operate the kettle without water or over-
fill: observe the min and max markings.
If the kettle is too full, the water will boil
over!
Before using for the first
time
■ Remove any stickers or film.
■ Unwind the cord to the required length
and plug in. The temperature display
a
and On/Off and U (keep warm)
buttons will light up briefly. A signal
sounds.
■ Fill the kettle with water and bring to the
boil twice to clean it thoroughly.
■ When the water comes to the boil for
the first time, add a tablespoon of white
vinegar.

Boiling water

1. Fill the kettle with fresh water through
the spout or the opened lid (press button
to open lid).
2. You can see the filling level on the water
level indicator. Observe the min and
max markings!
3. Close the lid, pressing down until it
clicks into place.
4. Place the kettle on the base.
a
5. Touch the On/Off button. A signal
will sound and the temperature last set
lights up.
6. A temperature between approx. 70°C
and approx. 100°C can be selected by
touching the temperature setting.
7. The water is heated.
8. Boiling stops automatically once
the specified temperature has been
reached. A signal sounds.
The temperature display lights up for
approx. 1 minute and then goes out.
Notes:
a
■ Touch the On/Off button to
re-heat water that has cooled down.
The temperature setting will be saved
as long as the appliance is connected to
a power source.
■ The temperature can be changed at any
time during the heating process.
■ When the kettle is placed on the base,
the temperature selected lights up
briefly.
■ While the kettle is heating up, the
temperature selected flashes until it has
been reached.
■ During the heating process the water
temperature currently reached is
displayed on the temperature setting.
■ If the temperature cannot be set, the
water in the kettle is hotter than the
desired temperature. The current
temperature lights up.
■ You can end heating at any time by
a
touching the On/Off button again.
en
9