WiringConnections - Jensen DMR2116 Manual Del Propietário

WIRINGCONNECTIONS

ISO Connector
A
B
Connector A
1. Rear right speaker (+) / Purple
2. Rear right speaker (-) / Purple - Black
3. Front right speaker (+) / Grey
4. Front right speaker (-) / Grey - Black
5. Front left speaker (+) / White
6. Front left speaker (-) / White - Black
7. Rear left speaker (+) /Green
8. Rear left speaker (-) / Green -Black
Speaker Wiring Notes
Follow the above wiring diagram to install the head unit with new or existing
speakers.
• This unit is designed for use with four (4) speakers with an impedance from
4 Ohms to 8 Ohms.
• An impedance load of less than 4 Ohms can damage the unit.
• Never bridge or combine the speaker wire outputs. When not using four
speakers, use electrical tape to tape the ends of the unused speaker outputs to
prevent a short circuit.
• Never ground the negative speaker terminals to chassis ground.
Fuse 10 A
DMR2116
Antenna Socket
RCA OUT
Left = White
Right = Red
Connector B
1. No connection
2. No connection
3. No connection
4. Battery 12 V (+) / Yellow
5. Antenna power / Blue
6. Panel light / White
7. ACC+ / Red
8. Ground / Black
15