Power Cord - Klarstein Glacial Manual Del Usuario

Water supply and drainage connection
Note: In regions with high calcareous water content, we recommend the use of a
water filter to maintain the functionality of the appliance. Replace it regularly.
• Usually, there is equipped with a water inlet pipe and a corrugated drain pipe
as a standard configuration in the unit. The standard configuration of the machine
installation and connection diagram is as follows:
Connect to drain pipe
Connect water pipe
• Only drinking water can be used on the ice maker.
• The water supply pressure should be 1–8 bar, if the water pressure is higher than 8
bar, a pressure relief valve must be used (not included).
• Since the drainage is carried out by the weight of the water itself, the drain pipe
should be installed with a sufficient gradient.

Power cord

EN
19