EN
20
1. Connect the right angle connector of the external inlet pipe to the G 1/2 " connector
on the rear cover and ensure that the rubber seal is in the correct position and
tighten the joint by hand to ensure no water leakage.
2. Connect the other end of the external inlet pipe to the faucet.
3. Connect the other end of the drain pipe (corrugated pipe) to the drain of the room.
Should ensure that the machine's outlet higher than the room outlet.
CONTROL PANEL, BUTTONS AND INDICATORS
Button
On/Off
In the standby mode, press the button to enter the ice making mode.
Press this button while the machine is running, the machine will stop
running and enter the standby mode.
Press the button 3 seconds, the blue light will be off.
/
Adjust the ice making time and the reservation time for power on/off,
they are displayed on the digital display.
Note: In the ice making mode, the digital display is always
illuminated an the ambient temperature is displayed. When the digital
display flashes, the countdown (minutes) until the end of the ice cube
making process is displayed. The timer indicator light will turn on when
the timer is activated.
Function description