Lighting Instructions; Troubleshooting - Member's Mark MG3208SLP Manual De Instrucciones

Manually Lighting Your Grill By Paper Match
To light your gas grill by match, insert a match into the
Lighting Stick and follow steps 1 through 6 of the Grill
Lighting Instructions. Then, light the match and place
Lighting Stick through the Cooking Grid on the grill as
shown below. Turn the nearest Control Knob to the HI
setting to release gas. The Burner should light immedi-
ately.
Match
Lighting
Stick
WARNING
!
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and body
a safe distance (at least 18 inches) from the
Lighting Hole or Burners when lighting your grill
by match.
WARNING
!
Should a FLASHBACK fire occur in or around
the Burner Tubes, follow the instructions below.
Failure to comply with these instructions could
result in a fire or explosion that could cause
serious bodily injury, death, or property damage.
Ÿ Shut off gas supply to the gas grill.
Ÿ
Turn the Control Knobs to OFF position.
Ÿ
Open the Grill Lid.
Ÿ
Put out any flame with a Class B fire
extinguisher.
Ÿ
Once the grill has cooled down, clean
the Burner Tubes and Burners according
to the cleaning instructions in this
Operator's Manual.
WARNING
!
If ignition does not occur in 5 seconds, turn the Control
Knob(s) and gas source OFF and conduct a leak test
as explained in the Use and Care section of this manual.
If no leaks are detected, wait 5 minutes for any gas
to clear and repeat the lighting procedure.
USE AND CARE INSTRUCTIONS
!
!
!

Troubleshooting

If the grill fails to light :
1. Turn gas off at source and turn Control Knobs to OFF.
Wait at least 5 minutes for gas to clear, then retry.
2. If your grill still fails to light, check gas supply and
connections.
3. Repeat lighting procedure. If your grill still fails to
operate, turn the gas off at source, turn the Control
Knobs to OFF, then check the following:
Misalignment of Burner Tubes over Orifices
Correction: Reposition Burner Tubes over Orifices.
Obstruction in gas line
Correction: Remove fuel line from grill. Do not smoke!
Open gas supply for one second to clear any obstruction WARNING
from fuel line. Close off gas supply at source and recon-
nect fuel line to grill.
Plugged Orifice
Correction: Remove Burners from grill by removing the
screw from the rear of each Burner using Phillips Head
Screwdriver. Carefully lift each Burner up and away from
gas valve Orifice. Remove the Orifice from gas valve and
gently clear any obstruction with a fine wire. Then
reinstall all Orifices, Burners, screws and cooking
components.
If an obstruction is suspected in Gas Valves or Manifold,
call the Grill Information Center 1-800-770-9769 8am to
4:30pm CST, Monday through Friday.
Obstruction in Burner Tubes
Correction: Follow the Burner Tube cleaning procedure
on page 26 of this Operator's Manual.
Misalignment of Ignitor on Burner
Correction: Check for proper position of the Electrode
Tip as shown in step 10 page 15. The gap between
the Spark Electrode Tip and Spark Receiver should be
approximately 3/16". Adjust if necessary. With the gas
supply closed push the Igniter Cap in and watch for the
presence of a spark within each Gas Collector Box.
Disconnected Electric Wires
Correction: Inspect the Ignitor Junction Box found behind
the Control Panel. Connect loose Electric wires to
Junction Box and try to light the grill.
Weak AA battery
Correction: Unscrew the Ignitor Cap and replace the
battery.
If the grill still does not light you may need to purge
air from the gas line or reset the regulator excess
gas flow device. Note: This procedure should be
done every time a new LP Gas tank is connected to
your grill.
To purge air from your gas line and/or reset
the regulator excess gas flow device:
Turn Control Knobs to the OFF position.
Turn off the gas at the tank valve.
Disconnect regulator from LP Gas tank.
Let unit stand 5 minutes to allow air to purge.
Reconnect regulator to the LP Gas tank.
Turn tank valve on SLOWLY 1/4 of a turn.
Open the Grill Lid.
Push and turn the Left Main Burner Control Knob to
ON/ .
Press Electric Ignitor for 3-4 seconds to light the
burners.
21