Tabla de contenido
Publicidad
2. SEPARATED PARTS
CALIBRE
Setting Stem
* Setting stem
Length of movement center to stem end...
Thread.................................
3. Others
* Measurement of time rate
The unit(gate) time of measurement must be set at "10s " or integer fold
value of 10s owing to the DFC system, and the measurement must be
performed in the form of complete watch.
* Marking on movement
* Typical clearance
Mov't - Caseback
Top of hands - Glass
* depending and subject to the glass and case structure, and hand length
4. Notice Of Casing
(1) The month corrector button should be hidden for preventing the error of action.
(2) The returning pressure of the month corrector button should be Min.200g
(3) The interval between Dial and Glass end should be 150 μm to avoid breakage
under drop.
5.Setting Instructions
(1) setting the day
Set the day by pulling out the crown to second click position and rotating it forward
( to rotate the hour and minute hands clockwise).
If the day is set by rotating the crown backyard (rotating the hour and minute hands
counter-clockwise), the date may not be changed.
Note: The day is changed during the period from about 0:00 AM to about 5:30 AM
(2) Setting the date (Quick change function)
Pull the crown out to the first click position and set the date by rotating the crown
backyard.
If the date is set beween 9:00 PM and 0:00 AM, the date will not change correctly.
(3) Setting the normal time
Pull the crown out to the second click position when the second hand reaches the
12 o'clock position so that the second hand stops there.
Then set the hour and minute hands.
When setting the minute hand, put it 4 to 5 minutes earlier than the time to be set,
and then turn it back to the correct time.
Note: The day is changed during the period from about 0:00 AM to about 5:30 AM.
After the time is set, push the crown back simultaneously with the time signal.
The second hand will start running at the same time.
(4) Setting the month
Each time the month setting button is pushed, the month is moved clockwise by
one month. If the button is not pushed to the end, the month is not changed perfectly.
Be sure to push it to the end firmly.
The month changes at about 0:00 AM on the 1st day of the next month.
Note: Do not change the month while the date hand lies between the 26th and the 31st.
In this case, set the date hand out of this period to adjust the month after this operation,
set the date hand again.
When the time passes from a month with 30 or less days to a 31-day month, please
correct the date hand. The month is also changed automatically.
This specifications might be changed without prior notice.
6P05
6P09
MIYOTA CO. UNADJUSTED
NO JEWEL JAPAN 6P50
6P25
6P27
065-379
065-379
20.03mm
Ф0.9 x 12.18mm
minimum 150 µm or more
300 - 400 µm *
6P29
6P89
Publicidad
Tabla de contenido
