Installing Back Camera - Dell Latitude 12 Manual Del Propietário

b. Remove the screws (3) that secures the back camera circuit board on the system board chassis [2].
NOTE: Finger print reader cable head is disconnected from the system board.
c. Lift the latch, and slide to remove the back camera board cable on the system board [3].
Ensure to remove all components, to resolve issues in bottom base assembly when troubleshooting issues are not
resolved by replacing the FRU-CRU components.

Installing back camera

1. Connect the back camera cable to the connector.
2. Align the back camera circuit board with the screw holes on the tablet chassis.
3. Replace the screws (3) to secure the back camera circuit board to the tablet chassis.
4. Connect the finger print reader cable on the system board.
CAUTION: Connect the cables to respective slot that were disconnected while removing the back camera
circuit board. See
5. Install the:
a. System board
b. WWAN
c. WLAN
d. System fan
e. Heat sink
f. Display assembly
g. Battery
6. Follow the procedure in
removing system board.
After working inside your computer.
Extracción e instalación de componentes 47