Installing Bottom Base Assembly - Dell Latitude 12 Manual Del Propietário

● Strapcover (Left and Right)
● Stylus Tube Assembly
● WLAN PTH Cable
CAUTION: Ensure to remove all components cable from the routing clip with a plastic scribe on the
system board. to avoid damage to the connected cables.

Installing bottom base assembly

1. Connect the back camera cable to the connector.
2. Align the back camera circuit board with the screw holes on the tablet chassis.
3. Replace the screws (3) to secure the back camera circuit board to the tablet chassis.
4. Connect the finger print reader cable on the system board.
CAUTION: Connect the cables to respective slot that were disconnected while removing the back camera
circuit board. See
5. Install the:
a. System board
b. WWAN
c. WLAN
d. System fan
e. Heat sink
f. Display assembly
g. Battery
6. Follow the procedure in
52 Extracción e instalación de componentes
removing system board.
After working inside your computer.