Micropuerto Serie Y Puerto Del Conector De Alimentación; Removing Micro Serial Port And Power Connector Port - Dell Latitude 12 Manual Del Propietário

6. Install the:
a. Display assembly
b. Battery
7. Follow the procedure in
Micropuerto serie y puerto del conector de
alimentación

Removing micro serial port and power connector port

1. Follow the procedure in
2. Remove the:
a. Battery
b. Display assembly
3. To remove the micro serial port and power connector port:
a. Place the back side of system on a flat surface.
b. Locate the micro serial port and power connector port.
c. Push to disconnect the power connecter cable [1] and remove the screw that secures power connector cable to the
system board [2].
d. Lift the latch and disconnect the micro serial port cable from the connector [3].
e. Lift the rubber bracket upward that secures the cable with system chassis [4].
NOTE: Ensure to release the bracket, after the micro serial port cable is connected.
f. Remove the metal bracket screws (5) that secure the micro serial port and USB-C port to the system chassis [5].
NOTE: Ensure to remove USB-C bracket in order to remove the micro serial port.
g. Lift the micro serial port bracket first, then the USB-C port bracket from the system [6].
h. Lift the micro serial port and power connector port on the system board [7].
NOTE: The micro serial port is still attached to the power connector port, lift only enough to set it aside in order to
remove the power connector port screw
i. Remove the screw (1) that secures the power connector port and lift the power connector port along with the micro
serial port from the system board [8,9].
After working inside your
Before working inside your
computer.
computer.
Extracción e instalación de componentes 27