Hoover LiNX BH50010 Manual Del Usuario página 5

3. MAINTENANCE
Dirt Cup & Filter Removal & Replacement
IMPORTANT: For best results, clean after each use.
REGULAR MAINTENANCE: Each time the dirt cup is emptied, the filter should be cleaned (Filter will be
discolored after use. This will not affect the filter's performance.)
Dirt Cup Removal and Cleaning
3. 1
To Remove dirt cup, depress
the dirt cup release button
located on the top of the dirt
cup and tip away from the
body of the unit.
Dirt Cup Debris and Clog Removal
In order to maintain optimum performance of your cleaner, each time
the dirt cup is removed for emptying it is recommended to check if there
is any debris trapped in the dirt tube (A). If so, remove the debris before
re-attaching the dirt cup to the cleaner.
If you still are experiencing reduced suction/performance, detach
the nozzle base from the main unit (press button on back of nozzle
to release, B) and inspect both openings of the nozzle base (C) for
any trapped debris. Remove any debris that may be present before
re-attaching the nozzle base to the main body of the cleaner.
Filter Removal and Cleaning
3.6
Pull out filter cap. Pull out filter and brush clean. Rinse under cold water
as needed.
For filter replacement, please call 1-800-944-9200 or visit our website at www.hoover.com to locate
a dealer nearest you. Filter Service Part # 410044001.
3.2
Press dirt cup empty button over trash can to release debris.
Push door closed until latch clicks.
3.7
3.3
3.4
A
3.5
B
C
WARNING: Always dry filter
for 24 hours before replacing.
WARNING: Do not use
detergent or hot water to clean
filter.