How To Operate - Hoover LiNX BH50010 Manual Del Usuario

2. HOW TO OPERATE

Assembly
2. 1
Nozzle
Release
Button
Line up nozzle with main body
and firmly push nozzle into
body of unit until nozzle locks
into place. NOTE: To remove,
push release button and pull
the nozzle away from the body
of the unit.
2.4
Charge battery fully before
first use. Fully discharged
battery will take up to 3 hours
to charge. NOTE: See battery
and charging manual for
battery charging instructions.
Use only manufacturer's
supplied or recommended
battery and charger.
2.7
To turn vacuum on, roll button
forward.
PUSH DIAL:
O - OFF
I - Suction ON
- Recommended for use on hard
floors.
II - Suction and Brushroll ON
- Recommended for use on carpet.
2.2
Insert handle into body.
NOTE: Ensure handle faces
proper direction.
2.5
Insert charged battery into
battery cavity until latch is
locked into place. NOTE:
When inserting and removing
battery, ensure the switch is in
the off position marked "O".
2.8
To remove and charge
battery, turn switch to off
position. Pull on release lever
located on end of battery and
pull out gently.
2.3
Insert screw and tighten until
secure.
NOTE: DO NOT over tighten
screw.
2.6
Hold down nozzle with foot and
tilt back to reclining position.