Dust Extraction; Maintenance And Cleaning - Würth EMS 350-SL COMPACT Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-0000000265-001.book Page 18 Monday, August 1, 2016 4:08 PM
Notes on sanding.
Press the power tool with the sanding sheet briefly and
firmly against a flat surface and briefly switch the
power tool on. This provides for good adhesion and
prevents premature wear.
When only one tip or corner of the sanding sheet is
worn, it can be removed again and reattached turned
by 120°.
Work with the entire surface of the sanding plate, not
only with the tip.
When sanding with small triangle sanding plates,
select a high oscillating frequency (electronics
level 4 – 6); when sanding with the round sanding
plate and the large triangle sanding plate, select a
moderate oscillating frequency (max. electronics
level 4).
Sand with continuous motion applying moderate pres-
sure. Applying excessive pressure does not increase
the rate of removal, it only wears off the sanding sheet
faster.
Notes on profile sanding.
Select a medium oscillating frequency.
Notes on sawing.
Select a high oscillating frequency. Round saw blades
can be released and clamped offset again, to allow for
uniform wearing off.
Notes on scraping.
Select a moderate to high oscillating frequency.

Dust Extraction

Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful
to one's health. Touching or breathing-in the dusts can
cause allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are consid-
ered as carcinogenic, especially in connection with
wood-treatment additives (chromate, wood preserva-
tive). Materials containing asbestos may only be
worked on by specialists.
• Where possible, use a dust extraction system suita-
ble for the material.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class respira-
tor.
Observe the relevant regulations in your country for the
materials being worked on.

Maintenance and Cleaning

When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool. The total
insulation of the power tool can be impaired. Blow out
the interior of the power tool via the ventilation slots fre-
quently with dry and oil-free compressed air, and con-
nect a residual current device (RCD) on the line side.
When the power tools's power cable is damaged, it
must be replaced by a qualified person using a spe-
cially prepaired power cable, available from your
Würth customer service agent.
If required, you can change the following
parts yourself:
Application tools
If the machine should fail despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by a Würth master-Service.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
The current spare parts list for this power tool can be
viewed in the Internet under
"http://www.wuerth.com/partsmanager"
or be requested from your next Würth branch office.
Guarantee
For this Würth power tool, we provide a guarantee in
accordance with the legal/country-specific regulations
from the date of purchase (verified by invoice or deliv-
ery document). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your Würth
sales representative or a customer service agent for
Würth compressed-air and power tools.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
18