Operating The Trimmer - Black and Decker NST2036 Manual De Instrucciones

90528621 36 volt trimmer 11/5/07
OPERATING INSTRUCTIONS
WARNING
:
• Always use proper eye protection that
conforms to ANSI Z87.1 (CAN/CSA Z94.3) while operating this
power tool.
• CAUTION: Inspect area to be trimmed and remove any wire, cord,
or string-like objects which could become entangled in the rotating
line or spool. Be particularly careful to avoid any wire which might
be bent outwardly into the path of the tool, such as barbs at the
base of a chain link fence.

OPERATING THE TRIMMER

The trimmer is equipped with a
variable speed trigger which allows for
greater control when trimming around
abrasive surfaces or heavier weeds.
The farther the trigger is pulled, the
faster the trimmer will run.
• Insert the fully charged battery into the
trimmer until you hear it "click" into place
as shown in figure J.
• To turn the trimmer on, pull the lock off
button (1), back and, then squeeze the
trigger switch (2) shown in Figure K.
In a few seconds or less you'll hear the
nylon line being cut automatically to the
proper length.
• To turn the tool off, release the trigger.
• To extend run
time, operate K
the trimmer
only as fast as
is needed to
get the job
1
done.
7:46 AM Page 10
• Hold trimmer with two hands and slowly swing trimmer side-to-side as
OPERATING THE TRIMMER USING THE SHOULDER STRAP
• Open the spring loaded ring as shown in figure M and insert the end
• Insert the end of the strap through the adjustable clip as shown in
• Place strap across left shoulder for
J
L
2
10
shown in Figure L.
through the opening in the plastic housing.
figure N and back down through the
other side as shown in figure O.
right hand users and right shoulder for
left hand users.
N
M
O