Troubleshooting - Black and Decker NST2036 Manual De Instrucciones

90528621 36 volt trimmer 11/5/07
Problem
• Line won't feed.
• Line fails to cut off.
• Unit will not start.
• Battery won't charge.
For assistance, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK &
DECKER help line at 1-800-544-6986.
7:46 AM Page 13

TROUBLESHOOTING

Possible Cause
• Line tangled in spool.
• Line cutter in guard is damaged or missing.
• Line extends past guard.
• Battery not installed properly.
• Battery not charged.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature too hot or too cold.
13
Possible Solution
• Unwrap 24 inches (610mm) of line and
rewind.
• Return to service center for repair.
• Rewind or trim line to line cutter.
• Check battery installation.
• Check battery charging requirements.
• Insert battery into charger until amber LED
appears.
• Plug charger into a working outlet. Refer to
"Important Charging Notes" for more details.
• Check current at receptacle by plugging in a
lamp or other appliance.
• Check to see if receptacle is connected to a
light switch which turns power off when you turn
out the lights.
• Move charger and tool to a surrounding air
temperature of above 40 degree F(4.5°C) or
below 105 degree F (+40.5°C).