Publicidad
Idiomas disponibles
Idiomas disponibles
9. FITTING THE UPPER FOCUS
BARS.-
Take the top left bar (9L) (marked with
the letter "L").
Insert the top bar onto the bottom left
focus bar (16L), lining up the letters
(L), Fig.10, fit the screws (87), the
washers (61) and tighten securely.
Now go through the same procedure
for the top right focus bar (9R).
10.- FITTING MONITOR.-
ATTACHING THE FEEDBACK
CABLE.
Take hold of the cable (91), which is
sticking up out of the main post (19),
Fig.11, and plug it into the connector
of the electronic unit (1), as shown in
Fig.11.
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(12), sticking out of the main post (19),
and plug them into the connectors
located at the back of the monitor (1),
as shown in Fig.11A.
ATTACHING THE MONITOR.-
Release screws (2), Fig.11, at the
back of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(19) in the direction of the arrow,
Fig.11, push the cables down into the
main post making sure not the pinch
any of the cables.
Replace the screws (2) removed
previously.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(88), located on the main post (19),
offering
various
Fig.11.
To increase pedal resistance turn the
tensioning control (88) clockwise (+)
until the exertion level best suits your
exercise requirements.
To reduce pedal resistance turn the
tensioning control (88) anticlockwise (-).
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits fl
at on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (66) up or down, as
shown in Fig.12.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (85)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.13. Store your unit in a dry place,
preferably not subject to changes in
temperature.
THE MANUFACTURER RESERVES
THE
RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
17
exertion
settings,
TO
MODIFY
OF
WITHOUT
PRIOR
THE
ITS
Publicidad
