Metrix HX0102 Manual De Instrucciones página 33

Chapter II
3.2.1. INST MODE (AC AND DC OUTPUT)
With the DC zero adjusted to within ±3mA, probe motionless.
Zero measurement error due to RMS noise:
Parameter
Resolution
Intrinsic error on amplitude (DC or sine wave)
Intrinsic error on phase at 3A and 50Hz
3.2.2. RMS MODE (DC OUTPUT)
With the DC zero adjusted to within ±3mA (or ±0.3mV) in "INST" mode, probe motionless.
Parameter
Resolution
Intrinsic error on amplitude (DC or sine wave)
3.2.3. OVERSHOOT OF RANGE
The red LED lights to indicate an overshoot of the range when the output voltage is above approximately
+2.2V DC or below -2.2V DC or peak.
3.2.4. MAINS ADAPTER
Parameter
Input voltage
Input current
Output voltage
Output current
Oscilloscope current probe
Value
3mA
± 1.5% ± 3mA
< 0,5°
Value
5mA
± 2% ± 30mA
Value
Mains voltage: 230 V , 50 Hz
ac
30mA
ac
9V
dc
150mA
dc
33