Step 14 Level Units - Monogram ZIW303NPPII Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
STEP 13 CONNECT HEATER (Cont.)
Locate the vertical, metal plate behind the vent cover.
There are two holes in the plate for mounting the
transformer. Locate the transformer on the plate and
attach using bolts, nuts and washers supplied.
In front of unit, unplug the power cord and replace
with the 'Y' splitter supplied in the kit. On the ends of
the splitter, plug in the transformer (black and white
leads) and the power cord plug.
Unplug main power cord
'Y' splitter
31-1000169 Rev. 4
Installation Instructions
Transformer
Metal plate
To transformer
Main power cord
29

STEP 14 LEVEL UNITS

All models have 4-point leveling. The front is supported
wheels. Both are accessible from the front of the unit.
nut located above the front wheels. Turn counter
clockwise to raise or clockwise to lower the unit.
Adjust height of unit to match installation cutout
opening. The unit should be level and plumb with
cabinetry.
NOTICE: The rear leveling wheels and front leveling
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening.
damage the front leveling legs and the rear leveling
wheels.
Hex Nut Adjusts
Up Up
Rear Wheels
Leveling Leg