Step 4. Adjust Door Swing (Unit 1); Step 5 Install Door Bracket Covers (Unit 1); Step 6 Installing Other Units; Step 7 Join Units - Monogram ZIW303NPPII Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
STEP 4 ADJUST DOOR SWING
(if needed)
NOTE: This unit has a 2-position door stop. When
space does not allow the door to swing to 115°,
you may limit the door swing to 90°. A 90° setting is
recommended for any installation where a unit has
another unit on both sides.
Skip this step if door opening is satisfactory for your
installation situation.
bottom hinges.
Loosen the bottom hinge screws that attached to the unit
hole nearest the unit.
them in place.
Repeat for top hinge.
WARNING
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly,
and door stop angle.
STEP 5 INSTALL DOOR BRACKET
COVERS (UNIT 1)
Install covers to hide the brackets near the hinges on the
top and bottom of the door. The covers snap in place.
Replace tape at the lower edge of the refrigerator door.
Installation Instructions
Install 1 pin,
per hinge for 90°
door stop.
Hinge screws
Door Trim Pinch Point
Hazard
Hinge
Door Bracket
Cover

STEP 6 INSTALLING OTHER UNITS

Complete Steps 2 through 5 on any other units being
installed.

STEP 7 JOIN UNITS

1. Move units in front of cabinet enclosure next to each
other, with top holes lined up. Using bolts, washers
together at the front - top and center. Tighten bolts
until spacer clips touch between units.
26 31-1000169 Rev. 4