Code; Example Of Programming Auto-Scan - Motorola XT420 Guia Del Usuario

Example of Programming a Code
Assuming the current code value is set to
factory default '001', and you want to change it
to CTCSS/DPL Code = 103. Follow the
sequence indicated below:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button twice. The radio
audible voice announced "Code Number"
(Entering CTCSS/DPL Programming Selection
Mode).
3. Pressing and holding SB1 or SB2 button fast
forwards / rewinds the value at the nearest 10's.
When released, the radio audible voice
announces the first, second and third digit in
full. Keep pressing the SB1 or SB2 button
several times until you hear "103".
4. Long press the PTT button. LED Indicator
shows a green heartbeat to indicate 'Idle'
Programming Mode.
5. Long press the PTT button again to exit
Programming Mode or turn OFF the radio.

Example of Programming Auto-Scan

Auto-Scan is the third available feature in the
Programming Mode and can be set to either
ON or OFF on a particular channel.
To set Auto-Scan to ON:
• Enter Advanced Configuration Mode and select
the desired channel.
• Short press the PTT button three times to enter
the Active Channels Programming Selection
Mode. The audible voice in the radio announces
"Auto-Scan" and the setting (Enabled or
Disabled).
• To change the setting, press SB1 or SB2.
• Long press the PTT button. LED Indicator shows
a green heartbeat to indicate 'Idle' Programming
Mode.
• Long press the PTT button again to exit
Programming Mode or turn OFF the radio.
31
English