Cequent Performance Products 30868 Instrucciones De Instalación página 6

7. Using a 18mm socket to remove all passenger side bed bolts and loosen or remove all driver side bed bolts. Then
raise and support the truck bed.(Only one side may need to be raised in which case the passenger side is
recommended.
8. Insert rails as shown in the following steps (Figures 9 through 14). With flat side up rear rail should be inserted
first. With flat side up insert front rail second. Refasten truck bed bolts after rails are inserted.
Front Hat Channel
F
Fuel
r
Cell
a
m
e
Rear Hat Channel
Figure 9
Step 1 : Slide one rail in behind the hat
channel located over the axel. Lift and
position it so that it rests on the frame.
Front Hat Channel
Fuel
Cell
Rear Hat Channel
Step 3 : Slide the front rail in over the
frame as shown.
Front Hat Channel
Fuel
Cell
Rear Hat Channel
Figure 13
Step 1 : Lift and rotate the rails over the
exhaust and towards the hat channel
30868N – 5/23/14 REV. E
F
Exhaust r
a
m
e
Exhaust
Figure 11
Note: Fig. 13-14 refer to the 6' Bed
Exhaust
PCN3694 ©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
Forward
Axel
Axel
Step 2 : Position the rail near the rear hat
channel as shown so that it rests evenly
Axel
Axel
Forward
Step 4 : Position the rail approximately
as shown so that it rests evenly on both
Forward
Axel
Step 2 : Slide the rails so that they rest
evenly on both sides of the frame as
Front Hat Channel
Fuel
Exhaust
Cell
Rear Hat Channel
Figure 10
on both sides of the frame.
Front Hat Channel
Fuel
Cell
Rear Hat Channel
Figure 12
sides of the frame.
Front Hat Channel
Exhaust
Fuel
Cell
Rear Hat Channel
Figure 14
shown
Printed in Mexico
Exhaust
6