Cequent Performance Products 30868 Instrucciones De Instalación página 8

11. Loosely attach frame brackets to frame using 5/8" x 2" carriage bolts, 5/8" conical washers, spacers, and 5/8" nuts
hand tighten (Figure 17&18). Slide spacer onto the carriage bolt and thread the carriage bolt into the pull wire.
Guide the pull wire through chassis (using access hole as shown), then guide the wire through the chassis to
position bolt and spacer through mounting holes. Loosely attach conical washer and nut from outside of frame rail.
5/8" Carriage bolt will
mount here using pull wire
from access hole
Figure 17
5/8" Nut ( 4 Locations )
5/8" Conical Washer ( 4 Locations )
Figure 18
Chassis cut away shown
to show where carriage
bolt and spacer will be
installed
30868N – 5/23/14 REV. E
PCN3694 ©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
Guide 5/8" carriage bolt
and spacer through
chassis opening here
Place 5/8" Carriage
Bolt and a spacer on a
pull wire (4 locations)
Access Hole for pull
wires (Located on
both sides)
Printed in Mexico
8