Cequent Performance Products 30868 Instrucciones De Instalación página 9

12. Using the drivers side edge of the bed corrugation, find the center of the truck bed. Measure the locations of the
holes that will need to be cut using Figure 20 (long bed application) or Figure 21 (short bed application). If a
plastic drop-in bed liner is used cut 19" X 4" slots in liner measured from center of holes in truck bed. If the REESE

Elite Series
fifth wheel assembly is used, then see fifth wheel slider assembly instructions for slot cut
slider
dimensions.
Truck Bed
13. Remove 5/8" x 2" bolts attaching frame bracket to mounting rails. Move rails rearward or forward to prevent
interference with hole drilling or punching of the truck bed.
30868N – 5/23/14 REV. E
Figure 20 – Long bed (8')
3-1/4" DIA.
4 PLCS.
3-1/2" DIA.
Truck Bed
Figure 21 – Short Bed (6')
3-1/4" DIA.
4 PLCS.
3-1/2" DIA.
PCN3694 ©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
42-3/8"
32-5/8"
Printed in Mexico

Tailgate
Tailgate
9