Tools And Materials Required; Remove The Packaging; Plan The Installation - Monogram ZVW1360 Instrucciones De Instalación

TOOLS AND MATERIALS REQUIRED

(NOT SUPPLIED)
Pencil and tape measure
Level
Electric drill with #2 Phillips
with 1/8" and 5/16" drill bits
UL listed wire nuts
10" round duct
Needed for back venting only
8"x12" to 12" round
duct transition
4
Installation Preparation
Safety glasses
Phillips screwdriver with
at least 6" shank
Wire cutter/stripper
Aluminized
duct tape
Strain relief for
junction box, 1"
diameter knockout
Gloves
12" round duct

REMOVE THE PACKAGING

CAUTION
Wear gloves to protect against sharp
edges.
Remove the hood body.
Remove the hardware bag, literature package and
other boxed parts.
Remove and properly discard the protective plastic
wrapping and other packaging materials.
Consider recycling options for your appliance
packaging material.

PLAN THE INSTALLATION

CAUTION
To reduce risk of fire and to properly
exhaust air, be sure to duct the air outside. Do not
vent exhaust air into spaces within walls or ceilings or
into attics, crawl spaces, or garages.
PARTS SUPPLIED FOR INSTALLATION
1 Hardware Package
1 Literature Package
1 Installation Template
PARTS NEEDED FOR INSTALLATION
1 Strain Relief
1 Wall or Roof Cap
All Metal Ductwork
WARNING
PERSONAL INJURY HAZARD
Because of the weight and size of the rangehood
canopy. It is recommended that 2 people are used
to install the range hood. Failure to properly lift
rangehood could result in damage to the product or
personal injury.
NOTE: Before making any cuts or holes for
installation, determine which venting method will be
used and carefully calculate all measurements.
31-2000734 Rev. 4