Tabla De Contenido; Axxess Interface Installation - Metra 95-6553B Instrucciones De Instalación

Chrysler 3002015 y mas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
• Retains safety chimes
• Retains the factory backup camera
• Retains the factory AUX-IN jack
• Retains balance and fade** Non-amplified models only.
• USB retention (with replacement parts included)
• Micro-B USB updatable
Note: Does not support surround camera (360) switching.
INTERFACE COMPONENTS
LD-CH5-T7 ..............................................................Chrysler car side harness for 7" touchscreen
LD-2NAVAMPL ........................................................Radio input harness
LD-SWC-F3.5 ..........................................................female 3.5mm adaptor
LD-TSCREENVID ......................................................4 pin camera input harness
LD-CHRYUSBAUX ...................................................USB knockout replacement harness
4

AXXESS INTERFACE INSTALLATION

TABLE OF CONTENTS
Connections ................................................................................................................................5-7
Installation .................................................................................................................................... 8
Programming ................................................................................................................................ 9
Touchscreen display operation ..............................................................................................10-12
Steering wheel control settings ............................................................................................ 13-14
Troubleshooting ...........................................................................................................................15
Final assembly .............................................................................................................................15
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun, solder, and heat shrink • Tape
• Wire cutter • Zip ties
|
386.257.1187
MetraOnline.com

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido