Installation - Metra 95-6553B Instrucciones De Instalación

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
1. Connect the 16-pin harness with stripped leads into port "B" in the touchscreen display.
2. Connect the car side harness to the wiring harnesses in the vehicle. Then insert the car side
harness into port "A" on the touchscreen display. But do not install this harness until exactly
before step 1 from the Programming section. This is a timed process
3. Connect the 4-pin harness with yellow RCA jacks into port "C" in the touchscreen display.
4. Connect the 2-pin harness into port "E" on the touchscreen display, and then to the wiring
harness in the vehicle.
5. Port "F" is an update port for future firmware upgrades. (Figure A)
6. Secure the touchscreen to the dash using the factory screws. (Figure B)
Continue to Programming
8

INSTALLATION

E
C
A
B
F
(Figure A)
(Figure B)
|
386.257.1187 MetraOnline.com