Programming - Metra 95-6553B Instrucciones De Instalación

1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured.
4. This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn't come on within 3 minutes,
and/or the touchscreen display does not show SWC Configured, check all connections, then reset
the interface and try again. Refer to the Troubleshooting section.
5. Cycle the key off. If the driver's door is closed, open and close the door. Cycle the key back on.
6. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The clock and compass in the driver's information center will no longer be functional.
Continue to Touchscreen display operation

PROGRAMMING

9
REV. 8/12/2021 INST95-6553B