Kit Assembly - Metra 95-6553B Instrucciones De Instalación

1. Attach the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
Note – the radio brackets will rest on
the factory dash snap locations and
place the radio in the correct location.
Before mounting, place the radio and
bracket assembly into the dash opening
and test fit the radio trim panel. It is
suggested to mark the holes and
pre-drill with a 1/8" drill bit. (Figure B)
Continue Axxess Interface Installation

KIT ASSEMBLY

(Figure A)
(Figure B)
3
REV. 8/12/2021 INST95-6553B