1. Unclip and remove the side trim panels
from each side of the console. (Figure A)
2. Remove (2) Phillips screws exposed on
pocket then remove the pocket. (Figure B)
2
DASH DISASSEMBLY
(Figure A)
(Figure B)
3. Remove (2) 8mm screws facing up on
bottom of radio chassis inside pocket
cavity. (Figure C)
4. Unclip and remove the small trim panel
between the radio and steering column.
Note: Models with auto climate will have
a thermistor hose attached to this panel.
Disconnect the hose under the dash
above the gas pedal to give it enough
slack before re-installing the panel.
(Figure D)
Continue on the next page
(Figure C)
(Figure D)
|
386.257.1187
MetraOnline.com