Kit Assembly; Iso Din Radio Provision With Pocket - Metra 99-7804 Instrucciones De Instalación

ISO DIN radio provision with pocket

1. Attach the radio brackets to the radio
housing trim panel using (4) of the #6 x
3/8" Phillips screws. (Figure A)
2. Attach the top bracket to the top of the
radio brackets using (4) of the #6 x 3/8"
Phillips screws supplied. (Figure B)
3. Mount the pocket to the bracket/panel
assembly with (4) of the #8 x 3/8"
Phillips screws supplied. (Figure C)
4. Slide the radio into the assembly and
secure with screws supplied with the
radio. (Figure D)
5. Attach the A/C vents to the radio trim
panel and secure using (2) of the
supplied #8 x 3/8" Phillips screws.
(Figure E)

KIT ASSEMBLY

(Figure A)
(Figure B)
6. Locate the factory wiring harness
in the dash. Follow the Wiring and
Initialization section of this manual
before completing the installation.
7. Mount the new radio assembly into the
dash and reassemble dash in reverse
order of disassembly.
(Figure C)
(Figure D)
(Figure E)
REV. 4/22/2021 INST99-7804
5