ISO DDIN radio provision
1. Attach the radio brackets to the radio
housing trim panel using (4) of the #6 x
3/8" Phillips screws. (Figure A)
2. Attach the top bracket to the top of the
radio brackets using (4) of the #6 x 3/8"
Phillips screws supplied. (Figure B)
3. Slide the radio into the bracket/trim
panel assembly and secure to the
assembly using the screws supplied
with the radio. (Figure C)
4. Attach the A/C vents to the radio trim
panel and secure using (2) of the
supplied #8 x 3/8" Phillips screws.
(Figure D)
6
KIT ASSEMBLY
KIT ASSEMBLY
(Figure A)
(Figure B)
5. Locate the factory wiring harness
in the dash. Follow the Wiring and
Initialization section of this manual
before completing the installation.
6. Reassemble the dash in reverse order of
disassembly.
(Figure C)
(Figure D)
|
386.257.1187
MetraOnline.com